Royal Oxylife RO purifier acts as a shield of purity against suspended solids, along with other contamination present in water. A combination of RO technologies with a high capacity of 10 Litre, it has ample capacity to provide fresh and purified water for a big family.
SMPS AdaptorAdaptor Output Power: 24VDC 2.5Amp/Max 3.0 Amp, Line Regulation (±): 0.5%, Load Regulation (±): 1%, Ripple & Noise (mV p-p): 250 Features: Overload Protection over Temperature Protection Short Circuit Protection Soft Start Longer service life Current Capacity: 2.5, ampere. SMPS Converts AC voltage to DC 24V.
Low-Pressure SwitchIf inlet water is not sufficient or at very low pressure then this switch stops the function of RO.
Once the inlet water supply starts properly LPS allow RO to function normally.
LPS avoids dry run of the booster pump.
The solenoid valve is an electromechanical actuated valve to control the flow of water. Solenoid valve works as an electronic tap, it allows water to go ahead when purifiers are on and it stops water when the purifier is off.
100 GPD Booster PumpThe purpose of the reverse osmosis booster pump is to increase water pressure going into the RO unit. We use 100 GPD RO Booster Pump for providing reliable inlet pressure for efficient membrane utilization. The offered booster pump is manufactured under the direction of skilled professionals utilizing quality raw material in accordance with the set industry norms.
Inlet Valve is used for connecting your RO/UV water purifiers with water tap inlet connector. It is made up of the standard quality material with the help of advanced technology. It helps to on/off water supply manually.
Quick Fitting PipeQuick fitting pipe is mostly used in advance RO water purifiers to make fittings fast easy and leak proof
SpannerIn RO water purifiers the first stage of purification is a Pre-sediment filter which is recommended to clean once in fortnight/month. Spanner is used to open the Pre-Filter bowl easily.
Teflon tape is used to make Inlet valve & tap fittings leak proof.
1) Customer has to inform on toll free or mobile when they receives the product.
2) We will arrange technician for installation of water purifier .Installation charges will be Rs.350/- to Rs.500/- depend on location and these charges are to be paid by customer only.
3) Technician may reach to your place within 12 hr but depend on location it may take 72 hr.
4) Mobile Number of technician will be given to you by SMS only.
5) Your address and registered mobile Number will be given to technician also.
6) It is customer’s duty to check whether installation is proper or not. Customer has to ask technician to show the TDS of pure water (Keep TDS between 30 to 70 ppm). Customer has to check for leakages and all before giving the installation charges.
7) For every visit customer has to pay the technician.
1) One year warranty on electrical parts, except UV Lamp. Warranty starts from date of dispatch.
2) Filters are consumables not covered in warranty, get blocked or choked because of water only. If water quality is good filters life will be more, If water quality is bad (More turbidity or more TDS) Filters life will be less.
3) Electrical part will be send through courier but technicians charge is to be pay by customer.